The CaddieCommand's built-in centering control will automatically center the front wheel everytime you stop transmitting a directional signal with the hand-held transmitter. The self-centering function will not work properly unless you center the front wheel USING THE ELECTRONICS. If the CaddieCommand is not centered, the motorcaddie will not track straight.

During normal operation, a sensor in the CaddieCommand is detecting course conditions and allowing for small terrain deviations, thus, allowing the caddie to follow a straight line of travel. If, for any reason, the front wheel becomes jammed and cannot return to center, the self-centering feature will shut-off after 6 seconds. To dislodge the obstacle, turn the power OFF and remove the obstruction. Turn the power back ON. The wheel should now automatically align itself. If it does not, re-adjust the thumb wheel.

The centering and directional control in the front wheel can be damaged if the unit rams into any obstacle. When the motorcaddie must be maneuvered in close areas, it may be best to do so manually; for instance, across bridges, around trees, or in parking lots. Damage caused by hitting obstacles is not covered under the manufacturers warranty. All CaddieCommand units MUST be returned to Kangaroo for proper repair. There are no user serviceable components inside.



Receiver Module

The receiver module is the main control center of the CaddieCommand. It processes and relays all of the signals from the transmitter to the front wheel. The receiver module is designed to receive a signal from the transmitter every 30 seconds. If for any reason the unit does not receive a signal within this time span, it will shut off. The auto shut-off will also stop the motorcaddie if it gets out of signal range. This is a required safety function to prevent a runaway motorcaddie. In normal use, most golfers will be making many directional adjustment signal transmissions. However, if periodic adjustment is not needed, and the motorcaddie stops, just press the GO button and the unit will start.


Hand-Held Transmitter

The transmitter is supplied with a fresh, standard Alkaline 9 volt battery. The battery compartment is located on the bottom rear of the transmitter. The cover slides off for easy battery replacement. Under normal use, the 9 volt battery should last 3 months. Replace the transmitter battery at least every six months.

The Red Light located on the top front of the transmitter, labeled "9v Battery", signals the user in two ways.

1. When a signal is given; the light will flash twice -- once with the pressing of the button, and again when the button is released. NOTE: The buttons are easy to press. There is no need for excessive force. When the indicator light flashes, the signal has been sent.

2. When the 9 volt battery is weak; the light will stay on continuously, indicating the 9 volt battery MUST be replaced. The CaddieCommand may have a loss of signal strength and a loss of range when the battery is weak. To test the battery, press and hold any function button. If the light stays on while the button is depressed, the battery is weak and should be replaced.

The position of the transmitter is important during signal transmission. In order to achieve maximum range, hold the transmitter with the control buttons on top and the back of the transmitter toward the ground. Point the front of the transmitter toward the motorcaddie. The transmitter will operate if held otherwise, but the overall operating range will be decreased. The range will also be affected if there are obstacles between you and the motorcaddie such as trees, buildings, cars, etc.

Reminder :

The arrows indicate steering direction as if you were operating the caddie manually. If the caddie is coming toward you, the steering direction of the arrows must be reversed.